Yamaha QL5 Reference Manual page 10

 DIRECT OUT field
This field enables you to make Direct Out settings.
1
Popup button
Press this button to open the INSERT/DIRECT OUT 1ch
window. The Direct Out level value will appear below the
button.
2
ON button
Switches the Direct Out on or off.
 RECALL SAFE field
This field enables you to make Recall Safe settings.
1
Popup button
Press this button to open the RECALL SAFE window.
2
ON button
Switches the Recall Safe status on or off.
3
PARTIAL indicator
This will light if recall safe applies only to some of the parameters, not to all channel
settings.
 FADER field
This field enables you to make settings for the channel on/off
status and the level.
1
Fader
Displays the current level.
Use the faders on the top panel to set the levels.
2
Level indicator
Displays the current level setting by numerical value. If
the signal is clipping at any point in the channel, the ΣCLIP indicator will light.
3
ON button
Switches the channel on or off. The button is linked with the corresponding [ON] key
on the top panel.
 DCA/MUTE field
This field enables you to select the DCA or mute group to which the
channel is assigned.
1
1 2
When the DCA group tab is selected:
2
3
1
3
2
When the mute group tab is selected:
4
5
2
6
3
1
10
Tabs
Select a DCA or mute group. Press the selected tab once again
to open the DCA/MUTE GROUP ASSIGN MODE window.
DCA group select buttons
Select the DCA group to which the channel is assigned.
Mute group indicators
Indicate the mute group to which the channel is assigned.
Mute group select buttons
Select the mute group to which the channel is assigned.
NOTE
If the dimmer level is set to the mute group, this button lights
orange.
MUTE SAFE button
Temporarily removes the channel from the mute group.
DCA group indicators
Indicate the DCA group to which the channel is assigned.
SELECTED CHANNEL section
1 1
3 3
2 2
5
6 4
Reference Manual