Hdvf-20A Viewfinder (Optional) - Sony HDW-650 Operation Manual

d LINE /AES/EBU / MIC selectors
These select the audio source of the audio input
signals input to the AUDIO IN CH1/CH2
connectors.
LINE: Line input audio equipment
AES/EBU: AES/EBU format audio signal
MIC: Microphone input
Note
When either of these selectors is in the MIC position, and
the corresponding +48V/OFF switch is in the +48V
position, and you inadvertently connect any audio device
other than a microphone to the corresponding connector
(AUDIO IN CH1 or CH2), the connected device may be
damaged.
e +48V/OFF switches
Select either of the following positions for the
microphones to be connected.
+48V: For a microphone that uses an external
power supply
OFF: For a microphone that uses an internal
power supply
f REMOTE connector (8-pin)
Connect an RM-B150/B750 Remote Control
Unit, which makes it possible to control the
camcorder remotely.
Note
Before connecting/disconnecting the Remote Control
Unit to/from the camcorder, be sure to turn off the
camcorder POWER switch.
g HDSDI OUT connector (BNC type)
Outputs an HDSDI signal (with embedded
audio).
h HD/SD SDI OUT connector (BNC type)
Outputs an HDSDI or SDSDI signal (with
embedded audio). To switch between HDSDI and
SDSDI output, use the HD/SD SDI OUT item on
the OUTPUT 1 page of the OPERATION menu.
Setting menus, timecode, or shot data can be
superimposed on the camera output video
depending on the menu settings, and you can
view them on the monitor screen.
i AUDIO IN CH1/CH2 (audio channel-1
and channel-2 input) connectors (XLR
type, 3-pin, female)
These are audio input connectors for channels 1
and 2 to which you can connect audio equipment
or a microphone.
When the LINE / AES/EBU / MIC selectors are
set to LINE or MIC, the CH1 connector is used
for channel-1 and -3 inputs, and the CH2
connector for channel-2 and -4 inputs.
When the LINE / AES/EBU / MIC selectors are
set to AES/EBU, the CH1 connector is used for
channel-1 and -2 inputs, and the CH2 connector,
for channel-3 and -4 inputs.
j AUDIO OUT connector (XLR type, 5-
pin, male)
Outputs the audio signals recorded on audio
channels 1 and 2 or audio channels 3 and 4. The
audio signals are selected by the MONITOR
switches.

HDVF-20A viewfinder (optional)

qf
qg
PEAKING CONTRAST BRIGHT
ZEBRA TALLY
DISPLAY
ON HIGH
OFF OFF
MOMENT LOW
ASPECT
a Plug
Connect to the VF connector on the camcorder.
b Stopper
Prevents the viewfinder from coming off the
camcorder when it is slid from side to side.
c Camera operator tally indicator
Lights up while camcorder is recording. This
indicator can be covered when not in use.
Locations and Functions of Parts and Controls
1
2
3
4
5
6
7
8
9
0
qa
qs
23