Cd Player Operation - Jensen JMC-180A User Manual

NOTE:
This unit not only plays commercial compact discs but also self-compiled CD-RW discs.
Because of non-standardized format definition/production of CD-R/RW, playback quality & performance is not
guaranteed.
Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as PC
performance, writing software, media properties etc.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
The following procedures can also be accomplished by using the remote control. Check the remote control diagram for
the corresponding buttons.
PLAY MODE
1. Press the STANDBY button (#5) located at the front of the main unit to turn on the system.
2 Press the MODE button (#17) repeatedly to select CD mode.
3 Open the CD DOOR by pressing the CD DOOR at the "OPEN/CLOSE" mark located on the CD door, load a CD
with the label side facing upward and then close the CD door.
4. Playback will start from track 1 once the Player has finished reading the TOC. The PLAY/PAUSE INDICATOR
" " will appear steadily on the LCD DISPLAY.
5. While playing, press the PLAY/PAUSE
Press the PLAY/PAUSE
6. Adjust the VOLUME +/- buttons (#8 or #9) to the desired volume level.
REPEAT MODE
REPEAT 1
When the REPEAT button (#19) is pressed once, the repeat Indicator
the LCD DISPLAY. The current track will be played repeatedly.
REPEAT ALL
When the REPEAT button (#19) is pressed twice, the repeat indicator
DISPLAY. The whole disc will be played continuously.
RANDOM PLAY MODE
When the REPEAT button (#19) is pressed three times to enter Random Play Mode, RAND will appear on the
LCD DISPLAY.
To Cancel Repeat or Random Function:
Press the REPEAT button (#19) repeatedly until the REPEAT indicator and RAND is gone.
SKIP AND SEARCH MODE
1. During Play or Pause mode, press the SKIP FORWARD
next track or go back to the beginning of the current track.
2. During playback, press and hold the SEARCH FORWARD
search within the current track with audible high speed playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Press the PROG button (#21) once. Program Number, "P01"will display and PROGRAM INDICATOR,
"PROG" will flash in the LCD DISPLAY.

CD PLAYER OPERATION

button (#14) to pause, the PLAY/PAUSE INDICATOR " " will flash.
button (#14) again to resume playing.
E-10
will appear steadily on the LCD
or SKIP BACKWARD
or SEARCH BACKWARD
will appear and flash on
buttons to go to the
Buttons to