Using The Remote Control Correctly; Setting The Clock - Jensen JMC-180A User Manual

I MPORTANT : Be sure that the batteries are installed correctly. Wrong polarity may damage the unit and void the
warranty. For best performance and longer operating time, we recommend the use of good quality alkaline type
batteries.
BATTERY CARE
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
If the unit is not to be used for an extended period of time, remove the battery. Old or leaking battery can cause
damage to the unit and may void the warranty.
Do not dispose of batteries in fire, batteries may explode or leak.
1. Plug the AC POWER CORD (#28) into a 120V AC ~ 60Hz outlet.
2. Press the STANDBY BUTTON (#5) to turn the unit on. The LCD DISPLAY backlight will light up.
3. Press the STANDBY BUTTON (#5) again, the unit will witch to standby mode. The LCD backlight will go off and
clock displayed.
Note: The Remote Control is only for operating the CD Player and Radio.
Point the Remote Control at the remote SENSOR (IR) (#20) located on the front of the System.
The functions of the remote buttons are the same as the corresponding controls on the main unit.
The performance of the Infrared SENSOR may be degraded causing unreliable operation if there is strong
ambient light source in the same room.
The recommended effective distance for remote operation is about 10-15 feet.
The clock has to be set before using the system for the first time. When you plug the system into an AC outlet for the
first time the clock display will show "12:00" and need to be set.
1. Press and hold the TIME ADJ button (#6), the hour and minute digits will flash.
2. Repeatedly press the HOUR button (#9) to set the correct Hour.
3. Repeatedly press the MIN button (#8) to set the correct Minutes.
4. Press the TIME ADJ button (#6) once to complete. The clock display will stop flashing.
NOTE
There is a PM INDICATOR located on the left-hand side of the clock display. Be sure to observe the PM
indicator when setting the time to make sure the time is set correctly for AM or PM. If the PM indicator appears, the
time displayed is "PM". If the PM indicator is not shown, the time displayed is "AM".
AC OPERATION

USING THE REMOTE CONTROL CORRECTLY

SETTING THE CLOCK

E-8