How To Ride Your Bike; Running In; Riding The Bike - Bajaj CT-100 User Manual

Location of Parts
Front Brake
Adjuster
Front Brake Adjustment
For safe riding the brakes must always be
maintained in perfect condition. Brake is
properly adjusted if -
• The wheel rotates freely when the control
lever is in the resting position.
• The braking action starts after Front brake
lever is pressed by 2-3 mm.
These conditions are obtained by adjusting the
cables by means of adjuster shown in the
figure & minor play adjustments can be done
by adjuster provided near front brake lever.
Rear Brake
Adjuster
Rear Brake Adjustment
Rear brake is properly adjusted if -
• The wheel rotates freely when the brake
pedal is in the resting position.
• The braking action starts after Brake pedal
is pressed by 20-30 mm.
These conditions are obtained by adjusting the
cables by means of adjuster shown in figure.
Both brakes, front and
WARNING :
rear must be maintained in perfect
condition, for road safety.
11

How to Ride Your Bike

Running IN

Proper running-in is important for the better life
& trouble free performance of the vehicle.
• During first 2000 kms running-in period do
not exceed following speed limits.
Kms 1st 2nd 3rd 4th
0 - 1000 15 30 45 55
1000 - 2000 20 40 60 75
• Always keep the speed below the limits
mentioned in the table.
• Do not race the engine excessively.
• Do not start moving or race the engine
immediately after starting. Run the engine
for a minute at idle speed to give the oil a
chance to work-up into the engine.

Riding the Bike

Before starting the vehicle & with the ignition
key 'OFF', adhere to the following first thing
in the morning or after a long period of non-
use (whichever is the case).
Depress the clutch lever completely. Kick the
kick lever all the way down to its stop, briskly
a couple of times. Release the clutch lever.
Starting the Engine :
• Keep the fuel tap to ON or RES position.
• Turn ignition switch to ON position.
• Confirm that the vehicle (transmission) is in
neutral.
• If the engine is cold or when starting for first
time, use choke for quick starting. Choke
lever (A) is located on LH side switch.
• Keep the throttle completely closed, and
kick the engine with kick starter lever.
• When the engine is warmed up enough to
idle without using choke, return the choke to
OFF position.
A1 : Choke "OFF"
A2 : Choke "ON"
A1
A
A2
12