How To Ride Your Bike; Running In; Riding The Bike; Starting Engine - Bajaj Pulsar 150 DTS-i Owner's Manual

How to Ride Your Bike

Running IN

Proper running-in is important for the better life and
trouble free performance of the vehicle.
• During first 2000 kms running-in period do not
exceed following speed limits.
Kms
0 - 1000
1000 - 2000
• Always keep the speed below the limits mentioned
in the table.
• Do not race the engine excessively.
• Do not start moving or race the engine immediately
after starting. Run the engine for a minute at idle
speed to give the oil a chance to workup into the
engine.

Riding the Bike

Before starting the vehicle and with the ignition key off,
adhere to the following first thing in the morning or after
a long period of non-use (whichever is the case).
Depress the clutch lever completely. Kick the kick lever
all the way down to its stop, briskly a couple of times.
Release the clutch lever.
11
Downloaded from www.Manualslib.com
1st 2nd 3rd 4th
15 30 45 55
20 40 55 65
manuals search engine
Starting the Engine :
• Keep the fuel tap to ON or RES position.
• Turn ignition switch to ON position.
• Turn Kill switch to (
• Confirm that the vehicle (transmission) is in neutral.
• If the engine is cold or when starting for first time.
5th
Use choke for quick starting. Choke lever (A) is
65
located on LH side of Carburettor.
75
• Keep the throttle completely closed, push the starter
button (
• When the engine is warmed up enough to idle
without using choke, return the choke to OFF
position.
A : Choke "OFF"
) ON position.
) or kick the engine with kick starter lever.
A
B : Choke "ON"
B