Using The Quick Menu; Adjusting Camera Image Settings - Lorex NR800 Series Instruction Manual

9
Using the System

9.2 Using the Quick Menu

The Quick menu gives you access to the system's key functions. To access the Quick
Menu, right-click the screen during live view.
The Quick Menu has the following options:
• View: Select a camera in full-screen or select a multi-channel display.
• Pan/Tilt/Zoom: Access controls for PTZ cameras (not included).
• AutoFocus: Access zoom/focus controls for auto-focus cameras (not included).
• Camera Setting: Configure image settings for cameras.
• Info: Opens the system information window.
• Sequence: Click to start/stop sequence mode.
In sequence mode, the system will automatically cycle through connected cameras
every few seconds. A
Click the icon to pause sequence mode on the channel that is currently shown (icon
changes to ). Click again to resume sequence mode.
Right-click and select Sequence to return to normal viewing mode.
• Disable Beep: Disable beeping alarms.
• Search: Search/playback recorded video. See 13 Search (Playback), page 32
• Manual Control: Click Record to open the Record menu to select manual recording
options. See 11.3 Setting up Scheduled or Manual Recording, page 28. Click Alarm
Output to control alarm ouput devices (not included).
• Device Search: Open the Device Search menu to manage IP cameras over the local
network.
• Main Menu: Open the Main Menu. See 16 Using the Main Menu, page 46.

9.3 Adjusting Camera Image Settings

Use the Camera menu to adjust image settings for your cameras.
To adjust image settings:
1. Right-click on the channel you would like to configure and select Camera Setting.
Enter the system password if prompted.
#LX400021; r. 4.0/30344/30494; en-US
will appear to show that sequence mode is on.
22