Configuring Video Loss Settings - Lorex NR800 Series Instruction Manual

16 Using the Main Menu
5. Under Anti-dither, enter the anti-dither time. After a motion event occurs and motion
stops, if motion is detected within the anti-dither time, the system continues the mo-
tion event and includes the new motion within the first event, rather than creating a
new motion event.
6. Under Post_REC, enter the time the system will record after a motion event occurs.
7. To configure a schedule when motion detection will be enabled on this channel, click
Setup next to Period. Configure times when motion detection will be enabled. For ex-
ample, you may want to disable motion detection during business hours and enable it
outside of business hours. Click OK when finished.
NOTE
This setting can override scheduled motion recording. This means that motion recording will only
take place at times that are enabled both in the Schedule menu and here.
8. Configure the following system actions when motion is detected:
• Alarm Out: Check the box to activate alarm output devices (not included) when
the selected channel detects motion. Select the alarm output devices will be acti-
vated when motion is detected.
• Latch: Enter the number of seconds an alarm output device will activate after mo-
tion is detected.
• Show Message: Check to enable an on-screen pop-up when one of your cam-
eras detects motion. On-screen pop-up shows the channels an event occurred on
and the type of event.
• Alarm Out: Check to enable the system to upload alerts to FLIR Cloud™ Client.
• Send Email: Check to enable email alerts. You must configure email alerts before
you will be able to receive them (see 16.3.5 Configuring Email Alerts, page 58).
• Channels: Select the channels that will record when motion is detected on the se-
lected channel.
• PTZ Activation: Check to enable PTZ actions when motion is detected (PTZ
camera required; not included). Click Setup to select which PTZ actions will be
taken by each camera.
• Sequence: Check to enable a custom sequence mode when motion is detected
on the selected channel. Then click the channels you would like to display in the
custom sequence mode.
• Buzzer: Check to enable the system buzzer.
• Snapshot: Check to save a snapshot when the camera detects motion.
9. Click OK to save changes.

16.3.9 Configuring Video Loss Settings

Video Loss occurs if the system loses connection to one of the cameras.
To configure Video Loss settings:
1. From the Main Menu, click
2. Under Channel, select the channel you would like to configure.
#LX400021; r. 4.0/30344/30494; en-US
and then click Event>Motion>Video Loss.
61