Built-In Fireplace Installation - Comfort Glow CGF265NV Owner's Operation And Installation Manual

INSTALLING
Continued
101920
8. Carefully insert fireplace into cabinet mantel. Be careful not to scratch or
damage hearth base, cabinet mantel, or any laminate trim on hearth base.
Remove protective material from top of hearth base and from front of fireplace
(if any). Note: You can secure fireplace to hearth or floor. Open lower louver.
Locate screw holes in bottom of base. Tighten wood screws through these
holes and into hearth or floor.
9. Check all gas connections for leaks. See Checking Gas Connections, page 18.
Figure 10 - Inserting Fireplace Into Cabinet Mantel

BUILT-IN FIREPLACE INSTALLATION

Built-in installation of this fireplace involves installing fireplace into a framed-in
enclosure. This makes the front of fireplace flush with wall. If installing a mantel above
the fireplace, but you must follow the clearances shown in Figure 15, page 15. Follow
the instructions below to install the fireplace in this manner.
Height
Actual Framing Actual
3
32 / " 33"
8
1. Frame in rough opening. Use dimensions shown in Figure 11 for the rough
opening.
Figure 11 - Rough Opening for Installing in Wall
Front Width Depth
Framing Actual
5 1
11
34 / " 35 / " 16 /
16
16 2
17 3/4"
33"
35 1/2"
Framing
3
" 17 / "
4
Continued
13