Paxar 9662 User Manual page 32

Appendix B:
INSTALLATION FOR CUTTER
1. Turn off the printer
2. Remove the top covers on both left and right sides.
3. Mount the cutter IC to U22 on main board; Take care of the location
and direction, the IC hole ix at lower Position.
4. Set bit 3 of DIP switch (1~8) to ON position.
5. Secure two screws for cutter (1) and bracket (2).
Note:
The drive IC for cutter is 3770.
61
6. Loosen two screws (4) from bracket (5).
,
7. Insert the left side of cutter bracket (7) and secure two screws (6) to
the TPH module.
62