Paxar 9662 User Manual page 14

Setting from Panel
You can change some settings from proper panel operation instead of
sending commands.
Buttons
PAUSE + CANCEL Enters setting mode.
(Don't press over 1 A second press will exit setting mode and return to
second) normal mode.
FEED Pressing this button will show next parameter.
PAUSE Pressing this button will show next setting item.
CANCEL Selects certain parameter and causes the
parameter to be saved in the permanent memory
(E PROM).
2
Except you change it from either panel or
command the parameter will be kept even you
restart the printer.
Procedure
Turn on the printer.
1. Till " READY" message is displayed on the LCD, press
[PAUSE]+[CANCEL] buttons simultaneously.
2. Press [PAUSE] button for several times to select the proper item that
you want to change the parameter.
3. Press [FEED] button till the specified parameter appears.
4. Press [CANCEL] button to save it. A "*" mark will appear at the last
column.
5. Press both [PAUSE] and [CANCEL] buttons at the same time, to
return to normal mode.
Note:
Do not make this operation during printing or communication.
25
Function
Selection Items
Item Range Factory Default
CUT/PEEL POS -15 ~ 15 mm 0 mm
(mm)
PRINT OFFSET -8 ~ 15 mm 0 mm
(mm)
TPH VER OFFS -3~3 mm 0 mm
(mm)
RECOVERY ENABLED, ENABLED
PRINT DISABLED
GAP HEIGHT MORE THAN 10 MORE THAN 10
mm, mm
5 ~ 7 mm,
8 ~ 9 mm.
WIN CON LEN 0 ~ 254 mm 0 mm
(mm)
BASE SPEED 0 ~ 4 IPS 0 IPS
(IPS)
COUNTER ON ENABLED, ENABLED
LCD DISABLED
MEDIA SENS. REFLECTIVE REFLECTIVE
TYPE SEE-THROUGH
Remarks
Controls cut and peeling
position.
Controls vertical print
position. Positive value
only.
Offset of vertical print
position
Contents reprint after
media-out or ribbon-out
This item appears only
when DIP switch bit 4 is at
ON position.
This takes effect only
when you run under
Windows with bundled
printer driver and use
continuous media.
This is for the PPLB
emulation only. When
you choose TLP2642/
3642 driver the speed is
limited under 2 ips. This
makes printer to upgrade
the speed.
Select the proper type by
the media
26