Setting The Direct Function; Setting The Digital Audio Input (For European Model) - Onkyo TX-8020 Instruction Manual

Enjoying Audio Sources
M
& ( # 5
SETUP

Setting the DIRECT Function

Press the [DIRECT] button. The message
"DIRECT MODE" appears.
When the DIRECT function is on, the
tone controls are bypassed, so you can
enjoy pure sound.
To cancel the DIRECT function, press the [TONE]
button again, and the message "TONE MODE" appears.
The tone controls can be used to adjust the sound.
You can configure whether the DIRECT function is
applied or not for input sources individually.
Setting the Digital Audio Input
(for European model)
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example,
if you connect your RI Dock to the OPTICAL, you must
assign "OPT" to the "DOCK" input selector.
Here are the default assignments.
Input selector
BD/DVD
TV
TAPE
DOCK
CD
COAX1, COAX2, OPT:
Select the corresponding digital audio input, to which
the component has been connected.
–––––:
Select if the component is connected to an analog audio
input.
Note:
The maximum sampling rate for PCM signals from a
digital input (optical and coaxial) is 96 kHz/24 bit.
22
En-
—Continued
TONE
DIRECT
ENTER
Default assignment
COAX2
OPT
–––––
–––––
COAX1
MON/STANDBY
DIRECT TONE
1 Press the [] button to turn on the power.
2 Press the [SETUP] button on the remote
controller.
3 Use the arrow []/[] buttons to select
"Digital Input," and then press [ENTER].
4 Press the arrow []/[] buttons to select the
input that you want to change the assignment.
For example, select "DOCK" to assign to "OPT".
5 Press the arrow []/[] buttons to select an
input terminal.
For example, select "OPT".
6 Press the [ENTER] button to confirm the
setting.
7 Press the [SETUP] button on the remote
controller to complete the setting.
Notes:
• This procedure can also be performed on the receiver
by using [SETUP], TUNING []/[], PRESET []/
[], and [ENTER].
• Press [RETURN] to return to the previous menu.
• This procedure will be cancelled if the [SETUP]
button is pressed before step 6.