Ferroli Xignal Service Instructions Manual page 29

10.2 Programming the boiler parameters 10.2 Programming the boiler parameters 10.2 Programming the boiler parameters
10.2 Programming the boiler parameters 10.2 Programming the boiler parameters
General information General information General information General information General information
For access to the boiler programming parameters, just depress the relative function keys. The
display indications will consequently change. Note that each key correspond to a single
function.
After having selected a function, it will be possible to quit data entry mode in two ways:
- automatically after 8 sec. if no key has been pressed
- by pressing the same function key again.
Boiler flow temperature Boiler flow temperature
Boiler flow temperature Boiler flow temperature Boiler flow temperature
Digit key . The following display message will appear
The delivery temperature may be regulated between 30° C and 85° C by means of the right-hand keys
NOTE NOTE
NOTE NOTE: When the external sensor is connected, set the temperature to 85°C and choose the compensation NOTE
curve.
Setting the compensation curve of the external probe Setting the compensation curve of the external probe Setting the compensation curve of the external probe
Setting the compensation curve of the external probe Setting the compensation curve of the external probe
Compensation curves must be set according to the characteristics of the heating system and the structural
features of the building. This function is only activated when the external probe is connected.
Press key twice for access to the programming mode. The following message will appear on the
display:
Set the desired curve (from 1 to 10) using the right-hand keys
page in order to choose the most suitable curve.
The external sensor will be disactivated if 0 is entered for the compensation curve.
CONTROL TEMP.
°
C.H.: 85 C
SELECT OTC CURVE
C.H.: 7
. Consult the table on the following
29