Table of Contents
Advertisement
DISPLAY
DISPLAY
DISPLAY
DISPLAY
DISPLAY
display
display
The alphanumerical display
display
display with 2 lines of 16 characters allows the user to check the operational
parameters of the boiler at any moment and to check the duration at the end of sanitary water production
or heating mode. The programmed values can also be displayed, plus the relative flow rate and
temperature during the production of sanitary water. Any faults are immediately indicated by the display
which starts to flash.
Indications during operation
Indications during operation
Indications during operation
Indications during operation
Indications during operation:
During operation, the display showes the time, the temperature of the water in the radiators, the pressure
in the plumbing circuit, the choice of summer or winter operation and timed or manual programming.
Heating flow
temperature
The following symbols may appear in the middle of the display:
-
- : indicates that daily programming has been activated
W-: indicates the hold status (2 minutes) after the maximum heating temperature has been reached, or
after hot water has been used.
At the beginning of a demand for heating or hot water, the display will indicate the type of demand for
8 sec. and, if hot water has been used, the relative flow rate.
The type and length of the demand will be displayed for 8 sec. at the end of the demand for heating or
hot water.
SPEAKING FUNCTION
SPEAKING FUNCTION
SPEAKING FUNCTION
SPEAKING FUNCTION
SPEAKING FUNCTION
Press key
and the computer will communicate the operative status of the boiler, the ambient
temperature and any faults by synthesized voice.
°
70
C
W
17:00
time
HEATING
DEMAND
D.H.W. DEMAND
FLOW RATE 13 L./MM.
END OF HEATING
DURATION 8 MIN.
END OF D.H.W.
DURATION 30 SEC.
system pressure
1,5 BAR
Summer Winter
WINTER
selection
27
Advertisement
Table of Contents
