Aluminum Wheel Precautions - Toyota 2005 Sienna Owner's Manual

Replacement with used wheels is not rec-
ommended as they may have been sub-
jected to rough treatment or high mileage
and could fail without warning. Also, bent
wheels which have been straightened may
have structural damage and
should not be used. Never use an inner
tube in a leaking wheel which is designed
for a tubeless tire.
CAUTION
Observe the following instructions.
Otherwise, an accident may occur re-
sulting in death or serious injuries.
Do not use wheels other than the
D
manufacturer's recommended size,
as this may cause dangerous han-
dling characteristics resulting
loss of control.
All−wheel drive models:
D
Do not use wheels of different
brands, sizes and types, as this
may cause dangerous handling
characteristics resulting in loss of
control.
Initial adjustment of the tire pressure
warning system is necessary after you
have replaced your wheels. See "Tire
pressure warning system" on page 196
in Section 1−7.
therefore
in
05 SIENNA_U (L/O 0409)

Aluminum wheel precautions

When
D
check that the wheel nuts are tight
after driving your vehicle the first 1600
km (1000 miles).
If you
D
changed your
wheel nuts are still tight after driving
1600 km (1000 miles).
When using tire chains, be careful not
D
to damage the aluminum wheels.
Use only
D
wrench designed for
wheels.
When balancing your wheels, use only
D
Toyota balance weights or equivalent
and a plastic or rubber hammer.
As with any wheel, periodically check
D
your aluminum wheels for damage. If
damaged, replace immediately.
2005 SIENNA from Sep. '04 Prod. (OM45431U)
installing aluminum wheels,
have rotated, repaired, or
tires, check that the
Toyota wheel nuts and
your aluminum
481