Toyota 2005 Sienna Owner's Manual page 338

Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand−held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface
HomeLink R .
Keep the indicator light on the HomeLink
in view while programming.
3. Press and hold the
HomeLink R button.
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light
HomeLink R changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink R button to program
another device.
330
Programming other devices
To program other devices such as home
R but- security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
of the
Individual HomeLink R
erased, however, to reprogram a single
R button, follow the procedure "Programming
the HomeLink R ".
selected (b) Operating the HomeLink
To operate the HomeLink
appropriate HomeLink R
the programmed device. The HomeLink
indicator light should
HomeLink R continues to send the signal
for up to 20 seconds as long as the
on the
button is pressed.
R by
05 SIENNA_U (L/O 0409)
(c) Erasing
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
buttons cannot be
the programs stored in the HomeLink
memory.
R
R , press the
button to activate
R
come on. The
2005 SIENNA from Sep. '04 Prod. (OM45431U)
the entire HomeLink R
R