Toyota 2005 Sienna Owner's Manual page 226

Hide thumbs Also See for 2005 Sienna:
Table of Contents

Advertisement

RESETTING TO A SLOWER SPEED
Push the lever down in the "− SET" direc-
tion and hold it. Release the lever when
the desired speed is attained. While the
lever is held down, the vehicle speed will
gradually decrease.
When the difference between the actual
vehicle speed and the set speed is less
than 5 km/h (3 mph), the set speed can
be lowered 1.6 km/h (1 mph) each time
by pushing the lever down in the "− SET"
direction quickly within 0.6 seconds.
However, a faster way to reset is to ac-
celerate the vehicle and then push the
lever down in the "− SET" direction.
Even if you downshift from "D" to "4" in
the conventional cruise control mode, en-
gine braking will not be enabled because
this mode is not cancelled. To decrease
the vehicle's speed, reset to a slower
speed with the cruise control lever or de-
press the brake pedal. If you use the
brake pedal, cruise control is cancelled.
218
05 SIENNA_U (L/O 0409)
RESUMING THE PRESET SPEED
If the preset speed is cancelled by pulling
the lever, by depressing the brake pedal
or by activating the vehicle stability con-
trol system, pushing the lever up in the
"+ RES" direction will restore the speed
set prior to cancellation.
If the preset speed is cancelled when ve-
hicle speed falls below about 40 km/h (25
mph), the preset speed will be resumed
when vehicle speed exceeds about 40
km/h (25 mph) again.
CONVENTIONAL
CRUISE
CONTROL
MODE FAILURE WARNING
If there is trouble in the conventional
cruise control mode, the "CRUISE" indica-
tor light in the instrument cluster flashes,
the master warning light comes on and
the alarm sounds, the warning code "E3"
will appear on the display.
If a system malfunction is detected when
the conventional cruise control mode is in
the ready mode or operating, the master
warning light comes on, an alarm sounds
and the above code appears.
If this code appears, press the "ON−OFF"
button to turn the system off and then
push it again to turn it on. If the setting
still cannot be made or the same code
appears again, the system might have
malfunctioned. Although there is no prob-
lem to continue driving, please contact
your Toyota dealer.
2005 SIENNA from Sep. '04 Prod. (OM45431U)

Advertisement

Table of Contents
loading

Table of Contents