Toyota 2005 Sienna Owner's Manual page 224

Do not use the conventional (fixed
D
speed) mode in the following condi-
tions, or serious injury or death
could result:
To help maintain maximum control
of your vehicle, do not use conven-
tional cruise control mode when us-
ing dynamic laser cruise control
while driving in heavy or varying
traffic, or on slippery (rainy, icy or
snow−covered) or winding roads.
Avoid vehicle speed increasing
when driving downhill. If the vehicle
speed is too fast in relation to the
preset speed in the conventional
cruise control mode, cancel
conventional cruise control mode
and then downshift the transmis-
sion to use engine braking to slow
down.
216
05 SIENNA_U (L/O 0409)
TURNING THE SYSTEM ON
To operate conventional
mode, press the "ON−OFF" button. This
the
turns the system on. The "CRUISE" and
"READY" indicator lights in the instrument
cluster comes on. Push the lever in the
"MODE" direction for longer than 1 second
to change to conventional cruise control
mode. The indicator in the instrument
cluster is as shown. You can now set
your desired cruising speed. Pressing the
"ON−OFF" button again will turn the sys-
tem completely off.
However, once the vehicle−to−vehicle dis-
tance control mode activates and is used,
it cannot be changed to the conventional
cruise control mode using the above op-
eration. To change the mode, press the
"ON−OFF" button to turn the system off
and then press it again to turn it on. Next
push the lever in the "MODE" direction for
longer than about 1 second.
To change to the vehicle−to−vehicle dis-
tance control mode from the conventional
cruise control mode, push the lever in the
"MODE" direction for longer than about 1
second.
cruise control
To avoid accidentally engaging cruise
control, keep the "ON−OFF" button
off when not using dynamic laser
cruise control.
2005 SIENNA from Sep. '04 Prod. (OM45431U)
CAUTION