Programming An Id - Motorola GP2000 Service Manual

Programming Mode
Keypad Button 1
6
7
8
9
0
4.10.3 Setting Up a Scan List
Scenario: To setup Scan List 2 with the following channels - CH 008, CH 036, CH 092, CH 083, CH
068.
Steps:
1. Enter Programming Mode, by pressing MON and turning on the radio.
2. Press + or - until RW is displayed.
3. Press PTT or MON until SCANLST2 is displayed.
4. Press +. The Þrst scan list member holder, 2-01-, will be displayed. Use the keypad to enter
008.
5. Press + again. Enter 036, when 2-02- appears, and subsequently in this manner, enter the
other channels.
NOTE: If a mistake is made, use + or - to move to the appropriate scan list member holder and
press # to erase the channel number.
6. Press PTT or MON, when all the channel numbers have been entered.
7. Turn off your radio, if you have completed the programming, or proceed to the next parame-
ter.
4.10.4

Programming an ID

Scenario: To program PTT ID with the value ÒA1018Ó.
Steps:
1. Enter Programming Mode, by pressing MON and turning on the radio.
2. Press + or - until RW is displayed.
3. Press PTT or MON until PTT-ID is displayed.
4. Press +. The cursor will be placed on the Þrst character.
5. Use the keypad and the programmable buttons to enter A1018.
NOTE: If a mistake is made, use + or - to move to the appropriate location and then re-enter the
correct character. To erase the complete ID, enter # 8 times.
st nd
Press 2 Press
6 M
7 P
8 T
9 W
0 +
rd th
3 Press 4 Press
N O
Q R
U V
X Y
- /
th th
5 Press 6 Press
S
Z
* #
4-21
th
7 Press
SPACE