Motorola GP2000 Service Manual page 51

Programming Mode
Channel
Description
Parameter
XXX-POWR Power Level
BCL-XXX Busy Channel
Lockout
CS Ð XX.X Channel Spac-
ing
SC-XXX Selective Call
(Selcall)
ACK-XXX Acknowledge-
ment Enabled
for Individual
Call
PID-XXX PTT ID
SCPL-XXX PL Required
for Selcall
Default
Range from
Factory
HI-POWR, HI-POWR
LOW-
POWR,
ECO-
POWR, RX
ONLY
BCL-OFF, BCL-OFF
BCL-ON
CS Ð 12.5, CS Ð 25.0
CS Ð 25.0
SC-OFF, SC-OFF
SC-ON
ACK-OFF, ACK-OFF
ACK-ON
PID-OFF, PID-OFF
PID-ON
SCPL-OFF, SCPL-OFF
SCPL-ON
Remarks
¥ Select the power level required for the channel.
¥ HI-POWR transmits at the maximum tuned power.
LOW-POWR is typically 1W and ECO-POWR, less
than 500mW. Set to RX ONLY if the channel is
intended as a Receive Only Channel.
¥ Press + or - to select the desired Tx power level.
¥ Select if the VFO is to enable Busy Channel Lock-
out (BCL).
¥ If BCL is enabled, the VFO will check for activity
before you can transmit. Detection of activity which is
not from the same group would prevent radio from
transmitting.
¥ Press + or - to select the desired BCL setting.
¥ Select the channel spacing for the VFO.
¥ Press + or - to select the desired channel spacing.
¥ Select if Selcall is to be enabled or disabled.
¥ If enabled, the VFO would adopt Signaling Squelch
Mode, i.e., unsquelch only if radio is receiving carrier
AND Selcall (matching ID).
¥ Press + or - to select the desired Selcall setting.
¥ Select if Acknowledgement is to be sent upon
receiving an Individual Call.
¥ If enabled, the preprogrammed Ack ID will be
replied once the Individual Call is received and car-
rier loss is detected.
¥ Press + or - to select the desired acknowledgement
setting.
¥ Select if PTT ID is to be sent upon PTT press.
¥ If enabled, PTT ID would be sent according to the
PTT ID Transmit Type selected in RW.
¥ Press + or - to select the desired PTT ID transmit
setting.
¥ Select if the VFO Rx PL/DPL is required for qualify-
ing the incoming Selcall.
¥ If enabled, incoming Selcall would be checked for
matching Rx PL/DPL before radio would unsquelch.
¥ Press + or - to select the desired setting.
4-17