Setting Terminal Parameters; Powering On The Switch - HP 5130 EI Switch Series Installation Manual

RJ-45
3
4
5
6
7
8
To connect a terminal (for example, a PC) to the switch:
1. Plug the DB-9 female connector of the console cable to the serial port of the PC.
2. Connect the RJ-45 connector to the console port of the switch.
NOTE:
Identify the mark on the console port and make sure you are connecting to the correct port.
•
The serial ports on PCs do not support hot swapping. To connect a PC to an operating switch, first
•
connect the PC end. To disconnect a PC from an operating switch, first disconnect the switch end.

Setting terminal parameters

To configure and manage the switch through the console port, you must run a terminal emulator program,
HyperTerminal or PuTTY, on your configuration terminal. For more information about the terminal
emulator programs, see the user guides for these programs.
The following are the required terminal settings:
Bits per second—9,600.
•
Data bits—8.
•
Stop bits—1.
•
• Parity—None.
Flow control—None.
•

Powering on the switch

Before powering on the switch, verify that the following conditions are met:
The power cord is correctly connected.
•
The input power voltage meets the requirement of the switch.
•
• The console cable is correctly connected.
The configuration terminal (a PC, for example) has started, and its serial port settings are consistent
•
with the console port settings on the switch.
Power on the switch. During the startup process, you can access Boot ROM menus to perform tasks such
as software upgrade and file management. The Boot ROM interface and menu options differ with
software versions. For more information about Boot ROM menu options, see the software-matching
release notes for the device.
Signal
TXD
SG
SG
RXD
DSR
CTS
22
DB-9
2
5
5
3
4
7
Signal
RXD
SG
SG
TXD
DTR
RTS