Pro-Form Crosswalk 415 User Manual page 9

7. Set the Console (87) face down on a soft surface
to avoid scratching the Console. Identify the Right
Handrail (90), which has a large hole in the loca-
tion shown. Hold the Right Handrail near the
Console. Attach the console ground wire to the
Right Handrail with a #8 x 1/2" Screw (22).
Next, insert the console wire into the large hole
in the Right Handrail (90) and out of the top as
shown. Attach the Right Handrail with three M4
x 19mm Screws (1). Make sure that no wires
are pinched. Start all three Screws before
tightening any of them; do not overtighten
the Screws.
Attach the Left Handrail (not shown) to the
Console (87) in the same way. Note: There are
no wires on the left side of the Console.
8. Have a second person hold the console assem-
bly near the Right Upright (78). Remove the wire
tie from the Upright Wire (77) and console wire.
Cut the plastic ties from the brackets on the Right
Handrail (90) and Left Handrail (not shown).
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors into
the Right Upright (78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make sure
that no wires are pinched.
9. Finger tighten two M8 x 25mm Bolts (6) with two
M8 Star Washers (10) into the Left Upright (73)
and the Left Handrail (89).
Next, finger tighten two M8 x 25mm Bolts (6)
with two M8 Star Washers (10) into the Right
Upright (78) and the Right Handrail (90). Then,
tighten all four Handrail Bolts.
See steps 4 and 6. Tighten the four M10 x
96mm Bolts (5).
7
90
1
Console
Ground Wire
22
87
8
Console
Assembly
90
Console Wire
77
78
9
89
6
6
73
10
9
Console
Wire
Large Hole
1
Console
Wire
77
6
90
10
10
6
78