Pro-Form Crosswalk 415 User Manual page 20

Hide thumbs Also See for Crosswalk 415:

Table of Contents

b. If the walking belt slips when walked on, first re-

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both rear roller bolts clock-

wise, 1/4 of a turn. When the walking belt is cor-

rectly tightened, you should be able to lift each side

of the walking belt 2 to 3 in. (5 to 7 cm) off the walk-

ing platform. Be careful to keep the walking belt

centered. Then, plug in the power cord, insert the

key, and carefully walk on the treadmill for a few

minutes. Repeat until the walking belt is properly

tightened.

PROBLEM: The crosswalk arms squeak during use

SOLUTION: a. (Note: Correcting this problem requires a small

amount of white marine grease, available at hard-

ware stores.) Turn the Resistance Knob (A) coun-

terclockwise and remove it. Next, remove the

Resistance Cone (B) and the Crosswalk Arm (76),

along with the Resistance Plate (C), Washers (D),

Spring Washer (E), Thrust Washers (F), and Thrust

Bearing (G). (Note: If the Resistance Plate [C]

comes out of the Resistance Cone [B], press it back

in.) Apply a thin layer of white marine grease to the

outer surface of the Resistance Cone (B). Then,

reattach all parts in the order shown at the right.

Table of Contents

Show Quick Links

Table of Contents