Spark Arrester - BOMBARDIER DS 650 Shop Manual

Remove oil filter and replace by a new.
NOTE: Check and change the O-ring, if necessary.
TYPICAL — RH SIDE OF ENGINE
1. Oil filter cover
2. Oil filter
3. O-ring
Wipe out any oil spillage on engine.
Inspect gasket on engine drain plug and replace as
necessary. Clean gasket area on engine and drain
plug then reinstall plug. Torque to 30 N•m (22 lbf•ft).
Refill oil tank at the proper level with the recom-
mended oil. Refer to TECHNICAL DATA for capacity.
NOTE: The same oil lubricates both engine and
transmission. Do not use synthetic oil, other than
Bombardier brand name, any semi-synthetic oil
or any special additives. They affect the clutching
calibration.
Start engine and let idle for a few minutes.
Check if the RED indicator lamp stays ON. If so,
stop engine and bleed system by removing oil fil-
ter and bleeding screw. See procedure below.
Ensure oil filter area, hose and drain plug areas are
not leaking.
Stop engine and check oil level. Refill as necessary.
Dispose oil as per your local environmental regula-
tions.
VMR2004_004_02_03A.FM
Section 02 MAINTENANCE
Subsection 03 (MAINTENANCE/LUBRICATION)
Bleeding Engine Oil Circuit
Remove oil filter.
Unfasten pressure bleeding screw.
BEHIND OIL FILTER
1. Bleeding screw
Unscrew and remove one spark plug.
Turn engine using starter until oil emerges in filter
chamber.
Tighten pressure bleeding screw. Torque to 25 N•m
(18 lbf•ft).
Install oil filter.

SPARK ARRESTER

The muffler must be periodically purged of accumu-
lated carbon. See the MAINTENANCE CHART.
Removal
Never perform this operation immediately af-
ter the engine has been run because exhaust
system is very hot. Wear eye protection and
gloves. Respect all applicable laws and regu-
lations.
WARNING
02-03-5