Kyocera FS-6025MFP/B Service Manual page 130

Code
7933 Sequence error 3
(Error in the reception of
backup data)
7943 Sequence error 4
(standby)
7953 Sequence error 5
(Error in between copies)
7963 Sequence error 6
9000 No original feed
9001 DP original conveying jam
9004 DP original switchback jam
9010 DP open
9011 DP top cover open
9110 DP paper feed sensor stay
jam
9200 DP registration sensor non
arrival jam
9400 DP timing sensor non arrival
jam
9410 DP timing sensor stay jam
*: Refer to figure 1-4-1 for paper jam location (see page 1-4-1).
Contents
A backup data command has been received in the
state the operation has initiated.
Start of operation has been received in the state of
prohibiting to stand by.
An illegal inter-page or inter-copy interval has
occurred.
The finisher does not deliver the eject-complete
command in 15 seconds after the bridge eject
sensor is turned off.
The DP paper feed sensor (DPPFS) does not turn
on within specified time during the first sheet feed-
ing (Retry 5 times).
DP timing sensor (DPTS) turns off within the speci-
fied time since the sensor turns on.
During duplex switchback scanning, the DP regis-
tration sensor (DPRS) does not turn on within
specified time of the DP timing sensor (DPTS)
turning off.
The DP is opened during original feeding.
Sensor in the conveying system is on when the
power is turned on or cover close.
The DP top cover is opened during original feed-
ing.
The DP paper feed sensor (DPPFS) or DP regis-
tration sensor (DPRS) does not turn off within
specified time of the DP timing sensor (DPTS)
turning on.
The DP registration sensor (DPRS) does not turn
on within specified time of the DP paper feed sen-
sor (DPPFS) turning on.
The DP timing sensor (DPTS) does not turn on
within specified time of the DP registration sensor
(DPRS) turning on (Retry 5 times).
The DP timing sensor (DPTS) does not turned off
within specified time its turning on.
Conditions
1-4-6
2K3/2L3-1
Jam
location*
K
K
K
K
L
N
P
-
-
N
M
M
N