Procedures For Programming Features - AT&T System 25 User Manual

Procedures for Programming Features

You can program FLEX DSS and Personal Speed Dialing Codes
on your cordless telephone. Before you begin this procedure,
your cordless phone should have been administered as set 303
by the System Administrator.
Lift the cordless handset from the base unit. (Make sure
1
On/Off is switched to
The LED will not be lit.
Use a ballpoint pen—not a pencil—to write the names of the
2
features you have selected to program on the corresponding
button labels.
To enter programming mode, slide the T/P switch (located on
3
the base unit) to P.
The Channel indicator will display a " P" to indicate programming mode.
or
Press [#] [4] .
Press On/Off.
4
The light will flash.
Keeping the handset close to the base unit, enter
5
the feature you are programming. *
Listen for confirmation tone and dial tone.
6
Press On/Off.
7
The light goes off.
If you used the T/P switch to enter programming
8
programming mode by sliding the switch back to
position.
the
* See AT&T System 25 Multiline Telephone User
on how to implement each feature.
Off.)
Guide for detailed procedures
the code for
mode, leave
the center
11