Host Parameters - Motorola Symbol LS1203 Product Reference Manual

6 - 4 Symbol LS1203 Product Reference Guide
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings
Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed in
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS terminal enables the
transmission of code ID characters listed in
programmable and are separate from the Transmit Code ID feature. The Transmit Code ID feature should not be
enabled for these terminals.
Terminal Specific RS-232
Table 6-2
Parameter
Transmit
Code ID
Data
Transmission
Format
Suffix
Baud Rate
Parity
Hardware
Handshaking
Software
Handshaking
Serial
Response
Time-out
Stop Bit
Select
ASCII Format
Beep On
<BEL>
RTS Line
State
Prefix
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar
codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear
unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling power to
the scanner.
Table 6-3 on page
Standard
ICL
(Default)
No Yes Yes
Data as is Data/Suffix Data/Suffix
CR/LF CR (1013) CR (1013)
(7013)
9600 9600 9600
None Even None
None RTS/CTS None
Option 3
None None None
2 Sec. 9.9 Sec. 2 Sec.
One One One
8-Bit 8-Bit 8-Bit
Disable Disable Disable
Low High Low
None None None
6-5. These code ID characters are not
Wincor-
Fujitsu Nixdorf
Mode B/
Mode A
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
Odd Odd
RTS/CTS RTS/CTS
Option 3 Option 3
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low = No
data to send
None None
(Table 6-2). Selecting the ICL, Fujitsu,
Wincor-
Nixdorf
Olivetti
OPOS
Yes
Prefix/Data/
Suffix
ETX (1002)
9600
Even
None
Ack/Nak
9.9 Sec.
One
7-Bit
Disable
Low
STX (1003)
Table 6-2.
Omron
Yes
Data/Suffix
CR (1013)
9600
None
None
None
9.9 Sec.
One
8-Bit
Disable
High
None