Carrier 40MBC/38MAQ Installation Instructions Manual page 13

INSTALLATION OF THE DECORATION PANEL
Detach the intake grill
1. Slide the two grille hooks toward the middle of the
decoration panel.
1
2
1 Intake grille
2 Grille hook
Fig. 24 --- Intake Grille
2. Open the intake grille and remove.
Fig. 25 --- Open Intake Grille
Install the decoration panel
1. Align the indication marks " " on the decoration panel to
the indication marks " " on the unit.
2. Attach the decoration panel to the unit with the supplied
screws (see Fig. 26).
1 Decoration panel
2 Screws (M5)(supplied with the panel)
Fig. 26 --- Attach the Decoration Panel
3. After installing the decoration panel, ensure there is no space
between the unit body and the decoration panel. Otherwise air
may leak through the gap and cause dewdrops (see Fig. 27).
4. Mount the intake grille. Ensure the buckles at the back of
the grille are properly seated in the panel's groove.
5. Connect the decoration panel's two wires to the unit's
mainboard.
5-core wire
1
2
13
Fig. 27 --- Eliminate Space
Fig. 28 --- Mount the Intake Grille
Fig. 29 --- Connect two wires
10-core wire