Command Reference Program (Using The Setup Disk) - Panasonic KX-P2130 Operating Instructions Manual

Command Reference Program
(Using the Setup Disk)
The Command Reference program allows you to access a detailed explanation of each software command on the
screen. Each displayed explanation can be printed out if required.
Before using the Setup Disk, it is recommended that you make a back-up copy and store the original in a safe
place.
Note:
• Use the DISK COPY command of the operating system to make a back-up copy. Refer to your DOS manual
for further information .
• You
may find it convenient to install the Setup Disk programs directly onto your C Drive, rather than reading
them from the Setup Disk each time a change is necessary. Either method is acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, refer to page 34.
1
Insert your Setup Disk into either drive A or B_
<For DOS>
2
Type A: (or B:) and press [Enter
~
3
Type CMDREF.
4
Press [ Enter
I.
S
The first screen is an introduction
to the operation of the Setup Disk.
Please read through it and press
any key to continue_
(If your display is monochrome,
press "M" key.)
Screen 1 will be displayed.
6
Press
C!J
or
w-
Select an emulation.
Note:
<For WINDOWS>
2
Select
I
Run
I
from the File menu.
3
Type A:\CMDREF (or B:\CMDREF).
4
Click 10K
I
(or press [Enter
I).
Screen 1
«
Panasonic KX-PXXXX command reference utility (xxxxxxxxxxx) »
- - SELECT EMULATION - -
IEP.SON
IBM
I t I
I
I I I
(Enter]
lEI
Select emulation
Set emulation
Exit to DOS
.You
can proceed through the Command Reference program using a computer mouse or your keyboard.
Highlight the desired item and click the left mouse button, or follow the directions on your screen for
'keyboard operation .
• There is a list of proportional spacing tables after the software commands list. If you want to see a
proportional spacing table, select your desired table and press ( Enter
I
51
en
i
Cil
o
o
3
3
III
:::s
C-
1/1