Tablet I/O Board - HP Pro x2 612 G1 Maintenance And Service Manual

Reverse this procedure to install the heat sink.

Tablet I/O board

Description
Tablet I/O board (includes 2 cables, audio-in/audio-out jack, docking port, micro memory card reader,
micro SIM slot, power connector, and USB port)
Before removing the tablet I/O board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Disconnect the tablet battery cable from the system board (see
Remove the tablet I/O board:
1. Release the ZIF connector (1) to which the tablet I/O board cable is attached, and then disconnect the
tablet I/O board cable from the system board.
2. Disconnect the speaker cables (2) from the tablet I/O board.
3. Release the ZIF connector (3) to which the home button board cable is attached, and then disconnect
the home button board cable from the tablet I/O board.
4. Release the ZIF connector (4) to which the tablet I/O board cable is attached, and then disconnect the
tablet I/O board cable from the system board.
Back cover on page 39).
Spare part number
773223-001
Tablet battery on page 44).
Tablet replacement procedures 59