Hinge Assembly - HP Pro x2 612 G1 Maintenance And Service Manual

Hinge assembly

Description
Hinge assembly (includes 2 alignment posts, 2 cables, docking connector, and release latch)
Before removing the hinge assembly, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Disconnect the tablet from the keyboard base.
5. Remove the bottom cover (see
a. Keyboard battery (see
b. Keyboard plate (see
c. Keyboard I/O board (see
Remove the hinge assembly:
1. Remove the six Philllips PM2.4×4.6 screws (1) that secure the hinge assembly to the top cover.
2. Remove the hinge assembly (2).
Reverse this procedure to install the hinge assembly.
76 Chapter 5 Removal and replacement procedures
Bottom cover on page
Keyboard battery on page
Keyboard plate on page 67)
Keyboard base I/O board on page
64), and then remove the following components:
65)
73).
Spare part number
766610-001