Xerox ColorQube 8570 Service Manual page 296

14. Disconnect the Waste Tray Detect Sensor wiring harness connector P/J102 from the I/O
Board.
15. Unlace the Sensor wiring harness from the retainers and guides.
16. Release the hooks that secure the Sensor to the cover and remove the Sensor.
Figure 4 Removing the Waste Tray Detect Sensor
Replacement
Perform the Homing the Printhead Forward to Print Position procedure (ADJ 1.2) and Process
Drive Alignment procedure (ADJ 1.3) before restoring printer power.
Repairs and Adjustments Revised, 3rd Revision - Xerox Internal Use Only
October 2012
REP 6.7
4-102 ColorQube 8570/8870 Service Manual