Hdmi Audio; Speaker Set - Yamaha RX-V367 Service Manual

RX-V367/HTR-3063

3. HDMI AUDIO

Using the sub-menu, the audio signals input to HDMI IN are selected and output.
* When selecting "DSD", be sure to connect an HDMI unit equipped with DSD output function to this unit.

4. SPEAKER SET

The analog switch settings for each sub-menu are as shown in the table below.
FRONT
CENTER : NONE
LFE/B
TONE
TONE
SPEAKER 6-ohm
LARGE: This mode is used for a speaker with high bass reproduction performance (a large unit). Full bandwidth
signals are output.
SMALL: This mode is used for a speaker with low bass reproduction performance (a small unit).
The signals of 90 Hz or less are mixed into the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3 dB and distributed to FRONT L/R.
SWFR: LFE of 5.1 channel signal or LFE/BASS lower than 90 Hz is output through SUBWOOFER OUT.
FRONT: LFE of 5.1 channel signal or LFE/BASS lower than 90 Hz is distributed to FRONT L/R.
34
3-1. SPDIF
3 . S P D I F
SPDIF signal is output.
3-2. Multi (DVD-Audio)
3 . M u l t i
Multi signal is output.
3-3. DSD (Direct stream digital)
3 . D S D
DSD signal is output.
FRONT
: SML 0dB SMALL
LARGE
: FRONT LARGE
: MAX LARGE
: MIN LARGE
LARGE
CENTER SURROUND
LARGE LARGE
NONE LARGE
SMALL SMALL
LARGE LARGE
LARGE LARGE
LARGE LARGE
SUBWOOFER
SWFR
SWFR
FRONT
SWFR
SWFR
SWFR