RX-V367/HTR-3063
22. SOFT SWITCH
When the following parts are replaced, the model name and the destination MUST be written to the back-up IC
(EEPROM: IC222 of the DIGITAL P.C.B.) to have proper operation.
• EEPROM (IC222) of DIGITAL P.C.B.
• DIGITAL P.C.B.
Note) When the DIGITAL P.C.B. is replaced, the firmware also must be updated to the latest version. (See
"UPDATING FIRMWARE")
22-1. SWITCH MODE
Press the "STRAIGHT" key to select the "22. SW: MODEL". This unit is in the mode where the name and the
destination can be written.
PCB:
Model name and destination can not be written.
MODEL: Model name and destination can be written.
22-2. MODEL
Press the "STRAIGHT" key to select the model name, "V367" (RX-V367) or "H3063" (HTR-3063). Selected model
name is written.
22-3. DESTINATION
Press the "STRAIGHT" key repeatedly to select the destination. Selected destination is written.
Press the "STRAIGHT" key is selected.
2 2 . D E S T : U
2 2 . D E S T : K
46
2 2 . S W
: P C B
Press the "STRAIGHT" key is selected.
2 2 . M O D E L : V 3 6 7
Press the "STRAIGHT" key is selected.
2 2 . D E S T : C
2 2 . D E S T : A
2 2 . S W
: M O D E L
2 2 . M O D E L : H 3 0 6 3
2 2 . D E S T : R
2 2 . D E S T : G
G: B, G, F models
2 2 . D E S T : T
2 2 . D E S T : L