Fl/Monitor Check - Yamaha RX-V367 Service Manual

7.

FL/MONITOR CHECK

This menu is used to check the FL display and video monitor output.
When checking the video monitor output, connect a TV monitor to this unit with a component video cable and video
pin cable.
Using the sub-menu, the FL display and video monitor output change together as shown below.
Checking FL display section
7-1. INITIAL DISPLAY
7-2. ALL SEGMENT OFF
7-3. ALL SEGMENT ON
7-4. DIMMER 50 %
7-5. CHECK PATTERN
Lighting in lattice
Short
Segment conditions of the FL driver and the FL tube are checked by turning ON and OFF all segments.
Next, the operation of the FL driver is checked by using the dimmer control.
Then a short between segments next to each other is checked by turning ON and OFF all segments alternately (in lattice).
(In the above example, the segments in the second row from the top are shorted.)
* After check, change to next
menu at once.
Normal
Check of the Video control section. (Monitor out)
MONITOR output ON
MONITOR (VIDEO) output mute
MONITOR (COMPONENT) output mute
MONITOR output ON
MONITOR output ON
RX-V367/HTR-3063
37