Programming The Internal Flash; Asynchronous Mode - Fujitsu SK-91465X-100PMC User Manual

4 Programming the internal Flash

All Flash devices have an internal bootloader for asynchronous as well as synchronous
Flash-programming:
< asynchronous-serial Flash-programming via X6 (UART A)
< synchronous-serial Flash-programming via J4

4.1 Asynchronous Mode

To use the asynchronous Flash programming mode, follow these steps:
1. Install the FME FR Flash programmer.
2. Connect the Starterkit (UART A) to the PC using a 1:1 cable.
3. Start the Flash programmer by double-clicking on the flashprg.exe icon
4. Select appropriate MCU type, COM-Port, baudrate, and the path to your HEX-File
(.mhx)
5. Power-off the board or assert and hold RESET
UG-910056-11
SK-91465X-100PMC User Guide
Chapter 4 Programming the internal Flash
- 24 - © Fujitsu Microelectronics Europe GmbH