Programming The Internal Flash - Fujitsu MOTORKIT-91F267-MC User Manual

4 Programming the internal Flash

In order to program the Flash ROM asynchronously via UART0, the tool "Fujitsu Flash MCU
Programmer for FR" can be used. This tool is available free on the Fujitsu Micros CD-ROM
or Web Site (http://mcu.emea.fujitsu.com/mcu_tool/software.htm)
The following procedure must be followed to perform Flash Programming:
1. Install the FJ FR Flash programmer.
2. Connect the Starterkit (UART 0) to the PC using a 1:1 cable.
3. Start the Flash programmer by double-clicking on the icon
4. Select appropriate MCU type, oscillator frequency, COM-Port, and the path to your
HEX-File (.mhx)
5. Power-off the board
6. Set JP18 to 2-3 (PRG) and power up the Board
7. Press the "Full Operation" button to start programming, press the RESET button
(SW6) and click on 'OK'.
CAUTION: DO NOT INTERRUPT OR CUT OFF POWER DURING ERASE!!!
8. When download and programming was completed successfully, a message appears.
In case of errors, please check COM-Port configuration, cable connection and jumper
settings.
9. After successful programming, Power off the board and set JP18 back to 1-2 (RUN)
10. Power on the board to start the application
© Fujitsu Microelectronics Europe GmbH
MotorKit-91F267-MC User Guide
- 23 -