Quadra-Fire QFI30FB Owner's Manual page 34

H. Install the Log Assembly
Log Set Assembly: LOGS-QFI35FB
Models: QFI35FB
2 2
SRV2223-701 SRV2223-701
5 5
SRV2223-704 SRV2223-704
6 6
SRV2223-705 SRV2223-705
BURNER LEDGE BURNER LEDGE
PILOT BRACKET PILOT BRACKET
LIGHT HOLES LIGHT HOLES
LOG PINS LOG PINS
GRATE BAR GRATE BAR
GRATE TINES GRATE TINES
Figure 2. Reference Points for Log Placement
CAUTION: Logs are fragile, handle with care.
Glass Rock (2201-853): Fill each light hole evenly with the glass rock. Use all of the glass rock provided.
FLAT SPOT FLAT SPOT
FOR LOG #7 FOR LOG #7
LOG #1 CONTACTS BURNER LOG #1 CONTACTS BURNER
LEDGE AT TWO POINTS LEDGE AT TWO POINTS
CENTER LOG CUT OUT CENTER LOG CUT OUT
OVER PILOT BRACKET OVER PILOT BRACKET
Figure 4. Place Log #1
Log #1 (SRV2223-703): Position Log #1 as shown in Figure 4. See Figure 2 for additional points of reference. Center the
log over the pilot bracket. The log should rest on the burner ledge as shown in Figure 4.
Log #2 (SRV2223-701): Position Log #2 as shown in Figure 5. See Figure 2 for additional points of reference. Place the
left end of the log on the rear log support. Slide the log back until it rest against the back of the log support. The left end of
the log should touch Log #1. Swing the right end of the log counterclockwise until it contacts the right refractory wall.
34
1 1
SRV2223-703 SRV2223-703
3 3
SRV2223-702 SRV2223-702
7 7
SRV2223-707 SRV2223-707
4 4
SRV2223-706 SRV2223-706
LOG SUPPORT LOG SUPPORT
BURNER BURNER
LEDGE LEDGE
1 1
Quadra-Fire • QFI30FB, QFI35FB • 2221-900 Rev. K • 3/11
Figure 1. Logs Installed
Figure 3. Install Glass Rock
LOG #2 TOUCHES LOG #2 TOUCHES
LOG #1 HERE LOG #1 HERE
FLAT SPOT FLAT SPOT
FOR LOG #6 FOR LOG #6
1 1
Figure 5. Place Log #2
GLASS ROCK GLASS ROCK
LOG #2 CONTACTS LOG #2 CONTACTS
RIGHT FIREBOX WALL RIGHT FIREBOX WALL
2 2