Table of Contents
Advertisement
B
The ventilation hose should not be connected
to the chimney of a stove or a fireplace.
B
Do not operate your product at the same time
with heaters such as a coal or gas stove.
Airflow may cause the chimney to flare up.
3.3 Adjusting feet
In order to ensure that your product operates more
silently and vibration-free, it must stand level and
balanced on its feet. Front feet of your product can be
adjusted. Balance the machine by adjusting the feet.
1. Loosen the feet by hand.
2. Adjust the feet until the product stands level and
firmly on the floor.
C
Do not use any tools to loosen the adjustable
feet, otherwise, they can be damaged.
C
Never remove the adjustable feet from their
housings.
You may supply 2 plastic pieces from an
C
Authorized Service with 2951620100 part
number. These parts prevent your machine
from slipping when the machine locates on
wet and slippery surfaces. You may assemble
mentioned parts to the front adjustable feet by
fitting and pressing them to snap into ground
of feet.
Dryer / User Manual
3.4 Electrical connection
Connect the machine to a grounded outlet protected
by a fuse of suitable capacity as stated in the technical
specifications table. Our company shall not be liable for
any damages that will arise when the machine is used
on a circuit without grounding.
• Connection must comply with national regulations.
• If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• Power cable plug must be within easy reach after
installation.
• The voltage and allowed fuse or breaker protection
are specified in the "Technical Specifications"
section.
• The specified voltage must be equal to your mains
voltage.
• Do not make connections via extension cables or
multi-plugs.
• The main fuse and switches must have a contact
distance of minimum 3 mm.
B
Damaged power cable must only be replaced
by a qualified electrician.
B
If the product is faulty, it must not be operated
unless it is repaired! There is the risk of
electric shock!
3.5 First use
• To have the product ready for operation before
calling the authorised service agent, make sure
that its location and power supply installations
are appropriate. If they are not, call a qualified
electrician to have any necessary arrangements
carried out.
• Make sure that the power connections of the
product are in accordance with the instructions
given in relevant chapters of this manual.
3.6 Transportation of the machine
1. Unplug the machine from the mains.
2. Remove the water drain (if any) and chimney
connections.
3. Drain water remained in the machine completely
before transportation.
3.7 Changing the illumination lamp
In case an illumination lamp is used in your laundry
dryer.
To change the Bulb/LED used for illumination of your
tumble dryer, call your Authorized Service.
The lamp(s) used in this appliance is not suitable for
household room illumination. The intended purpose of
this lamp is to assist the user to place laundry in the
tumble dryer in a comfortable way.
15 / 28 EN
Hide quick links:
Advertisement
Table of Contents
