Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beko DV 6120 X
Summary of Contents for Beko DV 6120 X
- Page 1 Dryer DV 6120 X 1 EN...
-
Page 2: Explanation Of Symbols
Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference. -
Page 3: Important Safety Information
Important safety information This section includes safety information that • Items cleaned or washed with gasoil/fuel oil, will help protection from risks of personal dry-laundry solvents and other combustible injuries or materialistic damages. Failure or explosive materials as well as the items to follow these instructions shall cause that are contaminated or spotted with such any warranty and reliability commitment to... -
Page 4: Intended Use
• Do not allow children sit/climb on or enter in Turn off the machine, disconnect the power the product. cord and contact an Beko Service. • Children should be supervised to ensure • Do not stop the dryer before the drying that they do not play with the product. -
Page 5: Appropriate Installation Location
Installation It is the customers responsibility to arrange placed on top of a washing machine, the a suitably qualified installer to correctly install approximate weight of both machines may this product. reach 180 kg when they are full. Therefore, Preparation of location and electrical the floor must be capable of carrying the installation for the product is under load on it! -
Page 6: Adjusting Feet
• Connection must comply with national regulations. • If the current value of the fuse or breaker in the house is less than 10 Amps, have a qualified electrician install a 10 Amp fuse. • Power cable plug must be within easy reach after installation. -
Page 7: Initial Preparations For Drying
Initial preparations for drying Things to be done for energy saving: A B C • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them. -
Page 8: Preparing Laundry For Drying
• Garments or pillows bolstered with rubber Place your laundry into the drum loosely so foam (latex foam), shower bonnets, water that they will not get tangled. resistant textiles, materials with rubber Large pieces (E.g.: bed sheets, quilt covers, reinforcement and rubber foam pads should large tablecloths) may bunch-up. -
Page 9: Control Panel
Selecting a Program and Operating Your Machine Control panel Synthetics Ready to Ready to Cottons Wear Timer Iron Programmes Extra dry 10 min Ready to Wear Clean Filter Drying 20 min Ready to Iron Start/ Pause Ready to Delicates Iron 40 min Ready to Wear... -
Page 10: Preparing The Machine
Preparing the machine laundry from creasing will be activated if you 1. Plug in your machine. do not take the laundry out after the program 2. Place the laundry in the machine. has come to an end. This program rotates 3. -
Page 11: Program Selection And Consumption Table
Program selection and consumption table Program table Approximate Spin speed in washing amount of Drying time Programs Capacity (kg) machine (rpm) remaining (minutes) humidity Cottons / Coloreds 1200-1000 % 60 900-800 % 70 Ready to Wear 1200-1000 % 60 80-60 900-800 % 70 110-80... -
Page 12: Warning Indicators
Dry” programme instead of “Iron Dry” Auxiliary function programme. Buzzer Cancel Models Equiped 2. Select the “Extra Dry” programme by Your machine will send out an buzzer warning rotating the programme selection button. when the program comes to an end. If you 3. -
Page 13: Technical Specifications
on the “Start/Pause/Cancel” and “Cancel the machine remains on hold until a new audio warning” buttons simultaneously for 3 programme is selected and the Start button seconds. is pressed. To start a new program after the program is Ending the program through canceling over or to interrupt the program, the childproof To cancel any selected programme;... -
Page 14: Maintenance And Cleaning
Maintenance and cleaning Filter Cartridge / Door Inner Surface Sensor (models equipped with a Lint and fibres released from the laundry to the sensor) air during the drying cycle are collected in the There are humidity sensors in your machine that “Filter Cartridge”. -
Page 15: Solution Suggestions For Problems
• The machine might have not been started by using the On/Off button. Make sure that the machine is On. • Bulb may have blown. Call Beko service to arrange for the bulb to be replaced. • The condenser cover on the models with a condenser might not be closed securely. Make sure that the condenser cover and the red lock is closed securely.