Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beko DV 7110
Summary of Contents for Beko DV 7110
- Page 1 DV 7110 Dryer...
-
Page 2: Explanation Of Symbols
Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference. -
Page 3: Important Safety Information
Important safety information or explosive materials as well as the items This section includes safety information that will that are contaminated or spotted with such help protection from risks of personal injuries materials should not be dried in the product or materialistic damages. -
Page 4: Intended Use
There is the risk of electric shock! Always product. disconnect by unplugging from the mains Children’s safety before cleaning. • Electrical appliances are dangerous for • Never touch the plug with wet hands. Never the children. Keep children away from the unplug by pulling on the cable, always machine when it is operating. -
Page 5: Appropriate Installation Location
Installation Refer to the nearest Authorised Service Agent reach 180 kg when they are full. Therefore, for installation of your product. the floor must be capable of carrying the Preparation of location and electrical load on it! installation for the product is under Ventilation hose and connection (for customer’s responsibility. -
Page 6: Adjusting Feet
Do not operate your product at the same If the product is faulty, it must not be time with heaters such as a coal or gas stove. operated unless it is repaired! There is the risk Airflow may cause the chimney to flare up. of electric shock! First use Adjusting feet... -
Page 7: Initial Preparations For Drying
Initial preparations for drying Things to be done for energy saving: A B C • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them. -
Page 8: Preparing Laundry For Drying
reinforcement and rubber foam pads dryer 1-2 times during drying process to should not be dried in the dryer. separate bunched-up laundry. • Do not use fabric softeners and anti-static Following weights are given as examples. products unless they are recommended by Approximate the manufacturers of the fabric softener or Home articles... -
Page 9: Selecting A Program And Operating Your Machine
Selecting a Program and Operating Your Machine Control panel 1. Filter cleaning warning light 4. On/Off button Warning light turns on when the filter is full. Used to turn on and off the machine. 2. Program follow-up indicator 5. Programme selection knob Used to follow-up the progress of the Used to select a programme. -
Page 10: Preparing The Machine
Preparing the machine 1. Plug in your machine. 2. Place the laundry in the machine. 3. Press the “On/Off” button. Pressing the “On/Off” button does not necessarily mean that the programme has started. Press “Start/Pause/Cancel” button of the machine to start the programme. Timer program selection Decide the appropriate time from the table below which includes drying temperature in... -
Page 11: Program Selection And Consumption Table
Program selection and consumption table Program table Approximate Capacity Spin speed in washing amount of Drying time Programs (kg) machine (rpm) remaining (minutes) humidity Cottons / Coloreds 1000 % 60 % 70 Ready to Wear 1000 % 60 80-100 % 70 100-130 1000 % 60... -
Page 12: Warning Indicators
program. Auxiliary function Any laundry added after the drying process Low temperature was started may cause the already dried This function allows for drying at lower clothes in the machine intermingle with wet temperatures and therefore saves energy. clothes and the result will be wet laundry after Warning LED will light up when you select the the drying process is over. -
Page 13: End Of Program
ventilation program to cool it down. If the machine is stopped during any drying program, and if the position of the program selection knob is changed, an audio signal will be heard (if the “Cancel audio warning” function is not selected). The machine will not start even if the “Start/ Pause/Cancel”... -
Page 14: Maintenance And Cleaning
Maintenance and cleaning Cover filter Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Cover Filter”. Such fibre and lint are generally formed during wearing and washing. Always clean the filter after each drying process. -
Page 15: Solution Suggestions For Problems
Solution suggestions for problems Problem Cause Explanation / Suggestion Drying process Cover filter and filter drawer might * Meshes of the filter may be clogged. takes too much have not been cleaned. Wash with water. time. * Cover filter and filter drawer might Laundry come out * Meshes of the filter may be clogged.