Monarch 6037 Quick Reference

M O N A R C H
™
6 0 3 7
G e t t i n g S t a r t e d
1.
Charge the main battery. Use either the Monarch® 9462™ or 9464™
battery charger. See the documentation for those chargers.
Important: You must charge the main battery before using it. For optimal
battery life, charge the battery
See the
information.
2.
Insert the main battery and the backup battery (if needed) in the printer.
A backup battery is already installed in the printer and ready to use.
3.
Attach the safety strap found in the documentation package.
4.
Load supplies in the printer.
5.
Turn on the printer. Your System Administrator must have already
loaded an application in the printer before you can use it.
A t t a c h i n g t h e S a f e t y S t r a p
1.
Turn the printer upside down, resting its top on the table.
2.
Take the thin end of the safety strap, and push it
through the loop at the bottom of the printer handle
(near the battery compartment).
TC6037QR Rev. AE 5/04
®
P A T H F I N D E R
P R I N T E R Q U I C K R E F E R E N C E
Equipment Manual
3.
Push the thick end of the safety
strap through the thin end's
loop.
4.
Pull the strap. It may be
necessary to help the thin
end's loop fit over the
plastic piece in the middle of the strap.
5.
Pull the strap tight.
®
U L T R A
within three months of receipt
for important battery safety
©2002 Paxar Corporation. All Rights Reserved.
®
G O L D
.