Table of Contents
Advertisement
Troubleshooting
The answering
system does not
answer after the
correct number
of rings
The answering
system does not
record message
The messages
on the answer-
ing system are
incomplete
The messages
on the system
are very difficult
to hear
The answering
system does
not respond to
remote com-
mands
ing system is on, the red light on the ANSWER ON key
should be lit.
two when there are new messages waiting (page 32).
system will answer after ten rings. If the memory is full,
you need to delete some old messages in order to make
room for new messages.
the ringing system used by the local telephone company.
and announce "Memory full. Enter remote access code."
You need to delete some old messages in order to make
room for new messages.
minutes, for each message, the system will disconnect and
part of the message may be lost.
tem stops recording and disconnects the call.
sage, the system stops recording and disconnects the call.
recording and disconnect the call.
VOLUME on the telephone base to increase the
speaker volume.
When dialing a number, you should hear tones. If you hear
clicks, then it is not a touch-tone telephone and cannot
activate the answering system.
code when your announcement is playing. Wait until the
announcement is over before entering the code.
using. Press the dial pad keys firmly when dialing.
45
-
-
-
Advertisement
Table of Contents
