Loading Paper; Loading Paper In The Paper Tray - FujiFilm Xerox Phaser 6270 User Manual

4.2

Loading Paper

Loading Paper in the Paper Tray

This section describes how to load paper in the tray and the 550 sheet feeder. All trays are
loaded the same way.
Important
• Do not remove the tray during printing. It may cause a paper jam.
1. Pull the tray out of the printer until it stops.
Hold the tray with both hands, lift the front
slightly, and remove it from the printer.
2. Slide the width guides to the edge of the
tray. The width guides should be fully
extended.
Note
• When loading paper that is 8.5 inches wide such as
Letter or Legal size paper, set the tab on the side of
the tray to the [8.5"] position.
3. While gently pressing the level on the back
of the tray inwards, extend the tray to fit the
paper size.
4. Before loading the print media, flex the
sheets back and forth, and then fan them.
Straighten the edges of the stack on a level
surface.
5. Place the print media into the tray with the recommended print side face up.
55
4.2 Loading Paper