SmartRG SR10 User Manual page 26

SmartRG™ Residential Gateways
IMPORT
ANT
To configure the WIRELESS interfaces...
5. On the primary SmartRG gateway: configure the WIRELESS interface following
the instructions in the "Use Case: Setting Up Wireless" section. Do NOT select
"Auto" for the Channel value.
6. On the remote SmartRG gateway(s): configure the WIRELESS interface
following the instructions in the "Use Case: Setting Up Wireless" section. Select
the same SSID, Security settings and Channel configured on the primary
gateway.
7. On the primary and remote SmartRG gateways:
1. select Wireless -> Wireless Bridge and set "AP Mode" to Access Point
2. set "Bridge Restrict" to Enabled(SCAN)
3. click Apply/Save and wait for the page to refresh
4. select the partner gateway (which has the same SSID as the primary
5. Click Apply/Save
IMPORT
ANT
Use Case: Creating IPTV Service Configurations" you MUST enable IGMP.
P a g e | 26
not included in the DHCP server pool on the primary SmartRG gateway.
At this point your web browser session will terminate as the LAN IP address has changed
from 192.168.1.1 to 192.168.1.x. Reconnect your web browser to the remote SmartRG
referencing the new LAN IP address.
gateway) by checking the box next to the SSID.
When more than two gateways are configured for WDS operation, the remote gateways
MUST NOT be partnered together to avoid creating an Ethernet loop.
C o n f i d e n t i a l S m a r t R G © 2 0 1 2