Figure 23 Wireless Distribution System
Configuring the SmartRG gateways for WDS operation requires the setting of WAN,
LAN and WIRELESS parameters on all gateways included in the WDS system.
To configure the WAN connections...
1. On the primary SmartRG gateway: configure the routed WAN connection
following the instructions in the "Use Case: Creating WAN Connections for
Internet Access and Remote Management" section.
2. On the remote SmartRG gateway(s): no WAN configuration is required as the
WAN connection is unused.
To configure the LAN interfaces...
3. On the primary SmartRG gateway:
a) configure the LAN interface following the instructions in the "Use Case:
b) ensure the DHCP Server is ENABLED and set the End IP Address such that
4. On the remote SmartRG gateway(s):
a) configure the LAN interface following the instructions in the "Use Case:
b) ensure the LAN IPaddress(es) are assigned from the remaining IP addresses
S m a r t R G © 2 0 1 2
Setting Up the LAN" section.
enough LAN IP addresses are left for static allocation to the remote
gateway(s) included in the WDS system.
Setting Up the LAN" section.
C o n f i d e n t i a l
Configuring Your SmartRG™ - Common Use Cases
P a g e
| 25