Designate Location For Dvr And Monitor; Connect Monitor/Cameras/Audio; Plan Mounting Locations For Cameras - Bunker Hill Security 62463 Owner's Manual & Safety Instructions

CONNECT AND TEST ALL EQUIPMENT AND CAMERA LOCATIONS
BEFORE MOUNTING CAMERAS.

Designate Location for DVR and Monitor

When planning location for DVR and Monitor:
1. Choose a clean, dry, well ventilated, dust-free
location indoors with a 120V outlet nearby.
2. If setting up Network access, make sure
the DVR is located close to a router.
A. Connect Monitor
Connect monitor or TV (sold separately) to DVR using:
BNC to RCA cable (included), HDMI cable (sold separately) or VGA cable (sold separately).
B. Connect Cameras and Audio
NOTICE: Do not join cables together end-to-end. Video loss may occur. If extra length is needed,
longer cables (sold separately) and a higher amperage power adapter (sold separately) should be used.
1. Connect Video (Yellow) from Cameras to Cables.
Note: Route Cables so that the end marked
TO CAMERA is at the Camera end.
2. Connect Power (Red) from Cameras to Cables.
3. Connect Video (Yellow) from Cables to DVR.
4. Connect Power from Cables to Splitter.
5. Connect Splitter to Camera Power Adapter.
6. Protect connections from moisture
with electrical tape.

Plan Mounting Locations for Cameras

DO NOT MOUNT CAMERAS yET!
Note: If adding extra cameras, use Item 62468.
1. Camera comes with Hood in storage
position. Pull Hood out to protect lens.
2. When planning mounting locations and angles:
a. Take into consideration the length of the Cables.
CAUTION! Route the Cables so as
to avoid a tripping hazard.
Item 62463
Hood
For technical questions, please call 1-888-866-5797.
3. Take into consideration the length
of the Camera Cables.
CAUTION! Route the Cables so as
to avoid a tripping hazard.
4. Make sure location will remain within
Operating Temperature.
7. Audio: Connect audio surveillance microphone
(sold separately) to Audio Input and
speaker (sold separately) to Audio Output.
• Go to Record > MainStream - Set
Resolution, FPS, Bitrate and Audio
on page 17 to enable audio.
• Go to Network > SubStream - Set Resolution,
FPS, Bitrate and Audio on page 31 to
enable audio during remote access.
NOTICE: CHECK FEDERAL, STATE AND
LOCAL AUDIO SURVEILLANCE LAWS
BEFORE INSTALLING MICROPHONE.
b. Choose locations under eaves to shelter
Cameras from rain and direct sunlight.
c. Choose locations high enough so that
Cameras are visible, but out of reach.
d. Verify that installation surfaces have no hidden
utility lines before drilling or driving screws.
e. Make sure no strong light will shine
directly into Camera Lenses.
f. To avoid mounting the Cameras upside down,
make sure the Hood is above the Lens.
g. Do not point Camera through a window, glaring
may occur, resulting in poor quality images.
Page 9