Clock Settings; User Management Settings - Bunker Hill Security 62463 Owner's Manual & Safety Instructions

Clock Settings

System > General - NTP (Network Time Protocol)
1. The DVR must be connected to your network
for this feature to work. (Go to Connect
DVR to Network on page 28)
Figure AC

User Management Settings

System > Users - Set up additional users' passwords and permissions.
To set password for main user, go to Password Settings on page 15.
Figure AD
Set up Additional Users
1. User Enable: Select Enable.
2. User Name: Enter User Name (up to 8 characters).
3. Password Enable: Select Enable or Disable.
a. Password: Enter Password (up to 6 characters).
b. Confirm: Enter Password again to confirm.
Changes will be saved when you
click Apply then OK.
Changes will not be saved if you click
Exit or right click on screen.
Page 22 For technical questions, please call 1-888-866-5797.
2. After network connection is set up:
a. Click NTP Setup.
b. Select Enable.
c. Choose Server Address.
d. Choose Time Zone.
e. Click Apply then OK.
f. Click Update Now.
The DVR's clock will be synchronized to
Coordinated Universal Time (UTC).
Changes will be saved when you
click Apply then OK.
Changes will not be saved if you click
Exit or right click on screen.
4. Select User that was just named
and click Permission.
a. Click in boxes to select specific permissions.
b. Click All to select all permissions.
c. Click Clear to remove all permissions.
Figure AE
Changes will be saved when you
click Apply then OK.
Changes will not be saved if you click
Exit or right click on screen.
5. Repeat steps above for other users.
Item 62463