Password Settings; Monitor Settings - Bunker Hill Security 62463 Owner's Manual & Safety Instructions

Password Settings

System > Users - Set
Password for main user.
(To add other users, go to User Management Settings on page 22)
1. admin is selected by default. Click
Edit at bottom of screen.
Figure J
2. User Name: Leave as admin or enter
another name (up to 8 characters).
3. Password Enable: Select Enable.
a. Password: Enter Password
(must be 6 characters).
b. Confirm: Enter Password again.

Monitor Settings

Display > Live - Set camera names, viewing positions, color and information to display on monitor
Figure L
1. Channel: Select which Channel to set up.
2. Name: Enter Channel name (up to 8 characters).
For example, "Garage" or "Backyard".
3. Position: Select where Channel Name
will appear on the monitor.
a. U-L: Upper Left
b. D-L: Lower Left.
c. U-R: Upper Right.
d. D-R: Lower Right.
e. Disable: No name will appear.
Item 62463
U
For technical questions, please call 1-888-866-5797.
Changes will be saved when you
click Apply then OK.
Changes will not be saved if you click
Exit or right click on screen.
Note: When Password is Enabled, a key
icon will appear on Pop-Up Menu.
Figure K
Note: To add other users, go to User
Management Settings on page 22.
NOTICE: If you are locked out of the DVR because
of a password problem, call 1-888-866-5797.
4. Color: Click Setup to adjust Hue,
Brightness, Contrast, and Saturation.
Changes will be saved when you
click Apply > OK > Exit.
Changes will not be saved if you click
Exit or right click on screen.
5. Covert: Disable is selected by default.
Select Enable to hide live image on monitor.
Note: Camera will still record even if the
image can't be seen on monitor.
6. Show Time: Enable is selected by default
to show date and time on monitor.
7. Record Time: Enable is selected by default
to show date and time on recordings.
8. Copy: Copy settings from one
Channel to other Channels.
a. Select Channel to copy from.
b. Select Channel to copy to or select ALL.
c. Click Copy, then click OK.
Changes will be saved when you
click Apply then OK.
Changes will not be saved if you click
Exit or right click on screen.
Click Default to restore default settings.
Page 15