Designate Location For Dvr And Monitor; Plan Mounting Locations For Cameras - Bunker Hill Security 61624 Owner's Manual & Safety Instructions

CONNECT AND TEST ALL EQUIPMENT AND CAMERA LOCATIONS
BEFORE MOUNTING CAMERAS.

Designate Location for DVR and Monitor

When planning location for DVR and Monitor:
1. Select a clean, dry, well ventilated, dust-free,
indoor location with a 120V outlet nearby.
2. If connecting DVR to Network, make sure
the DVR is located close to a router.
A. Connect Monitor
Connect monitor or TV (sold separately) to DVR using:
1. BNC to RCA cable (included),
2. HD cable (sold separately) or
B. Connect Cameras and Audio
NOTICE: Do not join cables together end-to-end. Video loss may occur. If extra length is needed,
longer cables (sold separately) and a higher amperage power adapter (sold separately) should be used.
1. Connect Video (Yellow) from Cameras
to Cables. Push together and twist
connectors clockwise to secure.
2. Connect Power (Red) from Cameras to Cables.
3. Connect Video (Yellow) from Cables to DVR.
4. Connect Power (Red) from Cables to Splitter.
5. Protect connections from moisture
with electrical tape.

Plan Mounting Locations for Cameras

DO NOT MOUNT CAMERAS yET!
Note: If adding extra cameras, use Item 62468.
1. Adjust Hood as needed to protect the lens.
2. When planning mounting locations and angles:
a. Take into consideration the length of the Cables.
CAUTION! Route the Cables so as
to avoid a tripping hazard.
C. Connect Mouse
Plug Mouse into either USB Port on back of DVR. Use Mouse to navigate DVR.
Item 61624
Hood
For technical questions, please call 1-888-866-5797.
3. Take into consideration the length
of the Camera Cables.
CAUTION! Route the Cables so as
to avoid a tripping hazard.
4. Make sure location will remain within
Operating Temperature.
3. VGA cable (sold separately).
6. Audio:
a. Connect up to 4 audio surveillance microphones
(sold separately) to Audio Inputs. All
connected microphones will record sound.
b. Connect speaker (sold separately) to
Audio Output. Only one channel at
a time can be live monitored.
c. Go to Audio Settings on
page 23 to enable audio.
NOTICE: CHECK FEDERAL, STATE AND
LOCAL AUDIO SURVEILLANCE LAWS
BEFORE INSTALLING MICROPHONE.
b. Select locations under eaves to shelter
Cameras from rain and direct sunlight.
c. Select locations high enough so that
Cameras are visible, but out of reach.
d. Verify that installation surfaces have no hidden
utility lines before drilling or driving screws.
e. Make sure no strong light will shine
directly into Camera Lenses.
f. To avoid mounting the Cameras upside down,
make sure the Hood is above the Lens.
g. Do not point Camera through a window, glaring
may occur, resulting in poor quality images.
Page 9